tip1:注意步数再24到32即可，过低的步数出图会扭曲，过高的步数会出现过拟合，

tip2:然后是lora的权重最好再0.4~0.68之间，太低出图就不像lora了，太高就会过拟合出现鬼图。

可以参考我做的图的参数

最后，记得点赞，点赞，点赞呀，

Tip 1: Pay attention to the number of steps between 24 and 32 when generating images. Too low of a step count can cause distortion in the image, while too high of a step count can lead to overfitting.

Tip 2: The weight for LORA should ideally be between 0.4 and 0.68. If the weight is too low, the generated image may not resemble LORA, and if it is too high, overfitting can occur, resulting in strange images.

You can refer to the parameters used in the image I generated.

Lastly, don't forget to like, like, like!