Tribbing / Scissoring Posing for Krea 2

Krea 2 cannot pose two females crotch to crotch so in order to help things along, I have trained this LoRA using curated images of real girls engaged in this activity.

VERSIONS:

v1.1 (NEW!): Trained locally using ai-toolkit on my 5090 over two stages:

1. Steps 0-3000 of 9 hand-captioned images with one girl on her back and the other straddling her.

2. Steps 3000-6000 builds on this with a further 10 hand-captioned images the classic equally seated position of both girls.

This version took two days of work to select images, caption, train and test so I'm gating this with Early Access for 3 days or 9K YB whichever comes soonest. Thank you for your support! My LoRAs are immediately available upon release to paid subs on my Riotmodels page.

Prompting tips:

Tribbing poses are by their nature unusual and complex so it can take some time to find the right prompt to bring out the correct pose. Per the above training description there are two basic poses. In your prompt I recommend the following structure:

• Define the characteristics of your women in two initial paragraphs and label them appropriately (e.g. G1 for Girl 1, G2 for Girl 2).

• Set the pose in the third paragraph. The two that I've found give the best results are as follows:

• G1 sits back with knees bent and legs parted. G2 also sitting back, straddles her sideways, one leg between G1’s thighs and the other outside, so their vaginas are firmly pressed against each other.

• G1 is lying flat on her back with her hands touching G2 and legs spread wide and slightly bent at the knees. G2 is kneeling on the bed between her legs, with her torso directly over G1's pelvis, her hands resting gently on G1's thigh and abdomen. Their vulvas are touching intimately, and their legs are intertwined — G2's legs are wrapped around G1's thighs, creating a close, connected position.

• Changing aspect ratio can also sometimes unstick a stubborn generation. 16:9 or 4:3 work best.

Different base checkpoints can affect the efficacy of the result. I have tested it on the base int8 convrot Krea 2 model, Cyberrealistic Krea 2 v2 and Sick Ollie.

Strength of 0.8 is usually fine but if it's being stubborn you can push it to 1.1.

- -
Multi LoRA Tip: I have been using this set of nodes and workflow for including two character LoRAs on a single image without bleed. It's a bit of a pain to set up, but once running will allow two or more of your girls to appear in the same scene beautifully.