这是在我以前的工作流插件上进行改进的升级版,
注意：这是一个采样器，同时也是一个简单的工作流，一个简单的采样器可以串联N个，这样可以达到多次采样，同时还具备外接其它插件。
别外还有一个版本没有发布，它内置了放大功能。

使用方法很简单，选好一切参数，输入提示词，外接保存图片节点，点运行就可以得到图片，不再像普通的其它工作流有繁所的节点，使画布变得简洁

模型选择：有分离式和整包选，整包适合以前的老模型，比如SD SDXL。分离试支持：flux /krea2/z image 等，

clip有二个，不管你用那个模型，第一个clip必须得选 ，第二用在双clip，如果没有双clip不用选，

其它的参数跟你一往一样选即可

This is an upgraded version of my previous workflow plugin.

Note: This acts as both a sampler and a simple workflow. You can chain multiple simple samplers together for multi-step sampling, and it also supports connecting to other external plugins. (By the way, there’s another unreleased version that comes with a built-in upscale feature!)

How to use:
It’s super simple. Just set your parameters, enter your prompt, connect an image-saving node, and hit Run to get your image. No more cluttered canvases with endless nodes like in typical workflows!

Model Selection:
You can choose between Unified and Separated modes:

• Unified mode: Best for older models like SD and SDXL.

• Separated mode: Supports Flux, Krea 2, Z Image, etc.

About CLIP:
There are two CLIP slots. No matter which model you use, the first CLIP is mandatory. The second one is only needed if your model requires dual CLIPs; otherwise, just leave it as is.

For all other parameters, just set them up exactly as you normally would!