v-pred test merge_normalsteps:This version might work fine at 16+ steps, and CFG around 3 (still relatively low CFG). these v-pred versions are still test merge, migt not be so stable. Normal<a target="_blank" rel="ugc" href="https://civarchive.com/models/835655?modelVersionId=1023901"> v3.0</a> might still be the best version to use.このバージョンは16ぐらいのStepsと、３ぐらいのCFG推奨です。 頭にvp0.5testとついたバージョンはまだテスト段階で、動作に不安定があるかも知れません。 安定性やクオリティ的には普通の<a target="_blank" rel="ugc" href="https://civarchive.com/models/835655?modelVersionId=1023901">v3.0</a>がまだ一番かと思います。<hr />v-pred test merge_lowsteps lowcfg:This is a personal merge based on noob vpred 0.5. While it still is a test merge, I'm uploading it as the results seem not bad. First, there are some points to note. Unlike previous EPS versions that were stable with moderate settings, this version is extremely sensitive to Sampler and CFG settings. Works nice at low CFG and low steps.Recommended Sampler: Euler a SGM Uniform (Not recommending just Euler) Recommended CFG: Between 1.0~1.5 Recommended Steps: 8+ Steps are recommended, but it also operates at a usable level with 4~6 Steps. Try it out for fun. Also, this is not necessary but it seems to work nice at 1024x1344 resolution.Noob vpred 0.5ベースのテストマージです。 テストマージではありますが、ある程度満足できる結果にはなりましたので、共有します。 まず注意点として、既存のPersonal mergeとは違い、SamplerやCFGにかなり敏感です。 低CFG推奨で、低Stepsでもいい感じの結果を出してくれます。推奨Sampler：Euler a SGM Uniform (ただのEulerはおススメしません) 推奨CFG：1.0~1.5 推奨Steps：8 Steps以上推奨ですが、4~6 Stepsでも割と使えるぐらいにはなりますので、試してみて下さい。 また、必須ではありませんが、1024x1344での結果がよさげでした。※ When using the vpred model, the following environments are required: Latest dev branch of a1111 webui Latest version of forge / reforge Latest version of comfyUI※ vpredモデルを使用するにあたって、以下の環境が必要です： a1111 webuiの最新のdevブランチ forge / reforgeの最新版 comfyUIの最新版<hr />v3.0:Seems to be quite an improvement for hands and human body, thanks to <a target="_blank" rel="ugc" href="https://civarchive.com/models/913998/noobaicyberfix?modelVersionId=1022962">NoobaiCyberFix</a> fix recipe.(hands and human body from <a target="_blank" rel="ugc" href="https://civarchive.com/models/312530/cyberrealistic-xl">CyberRealistic XL</a> and text encoder CLIP from <a target="_blank" rel="ugc" href="https://civarchive.com/models/833294?modelVersionId=1022833">NoobAI-XL v1.0</a>) Of course, thanks to noob 1.0, it also works better for e621-related dirty NSFW stuffs than previous version of personal merge.NoobaiCyberFixのレシピを導入したお陰で、手と人体に結構な向上が見られると思います。（CyberRealistic XLから手と人体のデータを取り、TE CLIPはNoobAI 1.0のものを使っています） もちろん、noob 1.0のお陰で、e621由来の汚いエロ絵も従来よりうまくこなせます。Full recipe: Implemented NoobaiCyberFix's fix recipe into 8:4:2:1:1 mix of <a target="_blank" rel="ugc" href="https://civarchive.com/models/833294?modelVersionId=1022833">NoobAI-XL v1.0,</a> <a target="_blank" rel="ugc" href="https://civarchive.com/models/246299?modelVersionId=1012153">comradeshipXL-v14T13B,</a> <a target="_blank" rel="ugc" href="https://civarchive.com/models/820208?modelVersionId=1014733">Obsession v2.1,</a> <a target="_blank" rel="ugc" href="https://civarchive.com/models/835578?modelVersionId=987116">PaSanctuary v2.0,</a> <a target="_blank" rel="ugc" href="https://civarchive.com/models/895391?modelVersionId=1001966">The I WonderMix v1</a><hr />v2.1:Merged 30% of noob-0.75 to v2.0. This version is currently my favorite personal merge. While sustaining stable and flat anime style, it's also very capable of e621-related dirty NSFW stuffs such as sc〇t or best〇〇〇ity. (these themes might not be suitable for civitai, so I'm not uploading examples)v2.0にnoob-0.75を30％混ぜたものです。 今んとこ自分用にマージした物の中で一番のお気に入りです。安定的かつフラットなアニメスタイルは維持しながらも、スカ〇ロや獣〇などe621由来の汚いエロ絵もバッチリです。（Civitaiの規約的に怪しいので画像は無しですが）<hr />v2.0:A simple merge of three noob-0.5 based models. 2:1:1 mix of <a target="_blank" rel="ugc" href="https://civarchive.com/models/246299?modelVersionId=997881">Comradeship v14T13A</a>, <a target="_blank" rel="ugc" href="https://civarchive.com/models/820208?modelVersionId=974379">Obsession v2.0</a> and <a target="_blank" rel="ugc" href="https://civarchive.com/models/835578?modelVersionId=987116">PaSanctuary V2</a> All credit goes to the original creators of each model.<hr />This is a simple merge model created for personal use by merging three Illustrious XL-based models.The Silvermoon, Comradeship, and Copycat models were merged in a ratio of approximately 1:2:2.It was originally intended for my personal use, but I'm sharing it because I'm quite pleased with the results.All credit goes to the original creators of each model.I'm using these quality prompts and negative prompts as below, but it seems to work well even if you remove them or reduce them. Feel free to use them according to your own preferences.Quality prompts: masterpiece, best quality, amazing quality, very aesthetic, absurdres Negative prompts: lowres, worst quality, bad quality, bad anatomy, jpeg artifacts, signature, watermark　個人的な使用用途で作ったIllustriou XLのマージです。Silvermoon、Comradeship、Copycatの３モデルを大体1:2:2ぐらいの比率で混ぜたものです。個人使用用途でしたが、なんか結果がかなり気に入ったので共有しておきます。元々のモデルの製作者さんたちに感謝いたします。自分は以下のようなQuality promptsとNegative promptsを使っていますが、別に適当かいっそ消しちゃっても結果が悪くない気がします。色々とやってみてください。Quality prompts: masterpiece, best quality, amazing quality, very aesthetic, absurdres Negative prompts: lowres, worst quality, bad quality, bad anatomy, jpeg artifacts, signature, watermark

Illustrious XL personal merge (noob v-pred0.5 test merge updated)

This is a personal merge based on noob vpred0.5. While it still has a strong test merge characteristic, I'm uploading it as the results seem not bad. First, there are some points to note. Unlike previous EPS versions that were stable with moderate settings, this version is extremely sensitive to Sampler and CFG settings.Recommended Sampler: Euler a SGM Uniform (Not recommending just Euler) Recommended CFG: Between 1.0~1.5 Recommended Steps: 8+ Steps are recommended, but it also operates at a usable level with 4~6 Steps. Try it out for fun.

Files with SHA256: 124192e2c27baf7097fe45b3421aeba3ddca1c1c8e192a22425751250fa98182